border
sSNAKESs : Reptile Forum
 

Go Back   sSNAKESs : Reptile Forum > Enclosure Creation Forums > General Enclosure Discussion

Notices

Closed Thread
 
Thread Tools Display Modes
Old 09-14-13, 01:37 AM   #1
h3h
Member
 
Join Date: Aug-2012
Posts: 441
Country:
Re: Zoo Med

Quote:
Originally Posted by desipooh.12 View Post
no I do not, & I've been trying to find a good affordable one & I have an idea of how they work but not exactly?

O_o You should have a thermostat before you get the snake, and you should get one asap. I hope you haven't burned your snake? A thermostat works like your air conditioner or heater in your house. You set the temperature you desire, and once that temperature has been obtained it shuts off the source until the temperature falls below the preset temp. Then it kicks back on again, and repeats that process.

- h3
h3h is offline  
Login to remove ads
Old 09-14-13, 01:39 AM   #2
Mikoh4792
Member
 
Mikoh4792's Avatar
 
Join Date: May-2013
Posts: 4,858
Country:
Re: Zoo Med

Quote:
Originally Posted by h3h View Post
O_o You should have a thermostat before you get the snake, and you should get one asap. I hope you haven't burned your snake? A thermostat works like your air conditioner or heater in your house. You set the temperature you desire, and once that temperature has been obtained it shuts off the source until the temperature falls below the preset temp. Then it kicks back on again, and repeats that process.

- h3
If it's on/off that's how it ^ works.


If you get a proportional thermostat, depending on the the type (pulse/dimming), it keeps the temps more steady by controlling the amount of power the heat source uses.
Mikoh4792 is offline  
Old 09-14-13, 09:38 AM   #3
desipooh.12
Member
 
desipooh.12's Avatar
 
Join Date: May-2013
Location: California
Age: 33
Posts: 315
Country:
Re: Zoo Med

Quote:
Originally Posted by Mikoh4792 View Post
If it's on/off that's how it ^ works.


If you get a proportional thermostat, depending on the the type (pulse/dimming), it keeps the temps more steady by controlling the amount of power the heat source uses.
any suggestions on where I can get one?
__________________
"Ignorance-the state or fact of being ignorant; lack of knowledge or learning" , not for asking a question you jackass!
desipooh.12 is offline  
Old 09-14-13, 11:24 AM   #4
h3h
Member
 
Join Date: Aug-2012
Posts: 441
Country:
Re: Zoo Med

Quote:
Originally Posted by Mikoh4792 View Post
If it's on/off that's how it ^ works.
If you get a proportional thermostat, depending on the the type (pulse/dimming), it keeps the temps more steady by controlling the amount of power the heat source uses.

Good point, I believe these are a little more expensive than the ones I mentioned. They probably also do a better job - I use one as described by me in the previous post, I've never had much fluctuation, through experiimentation I can "under set" the desired heat, and when the stat tells the heat to kick off it will still rise a degree or two to the desired temp!

- h3
h3h is offline  
Old 09-14-13, 09:37 AM   #5
desipooh.12
Member
 
desipooh.12's Avatar
 
Join Date: May-2013
Location: California
Age: 33
Posts: 315
Country:
Re: Zoo Med

Quote:
Originally Posted by h3h View Post
O_o You should have a thermostat before you get the snake, and you should get one asap. I hope you haven't burned your snake? A thermostat works like your air conditioner or heater in your house. You set the temperature you desire, and once that temperature has been obtained it shuts off the source until the temperature falls below the preset temp. Then it kicks back on again, and repeats that process.

- h3
No I have not burned my snake, because my heat pad is on the outside of the tub & I've put my probe on the heat pad & its not heating like its suppose to that's the reason I made this thread lol..
but yes I figured that's how it works, I've just had a hard time finding one..
__________________
"Ignorance-the state or fact of being ignorant; lack of knowledge or learning" , not for asking a question you jackass!
desipooh.12 is offline  
Login to remove ads
Closed Thread


Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 05:30 AM.

Powered by vBulletin®
©2000 - 2025, Jelsoft Enterprises Ltd.
Copyright © 2002-2023, Hobby Solutions.

right