border
sSNAKESs : Reptile Forum
 

Go Back   sSNAKESs : Reptile Forum > Community Forums > General Discussion
Reload this Page Newbie set up questions
Register FAQ Calendar Search Today's Posts Mark Forums Read

Notices

Closed Thread
 
Thread Tools Display Modes
Old 10-17-17, 12:45 PM   #1
SpiralEquinox
Member
 
Join Date: Apr-2017
Posts: 8
Country:
Newbie set up questions
I'm setting up my snakes tank now and didn't think of this before but will the wires be ok if I put the lid on tight? Or should I feed it through the top. I don't want to crush the wire of an expensive thermostat! Also how long do UTH pads take to warm up. Seems like it's taking a while 🤔
SpiralEquinox is offline  
Login to remove ads
Old 10-17-17, 03:27 PM   #2
EL Ziggy
Forum Moderator
 
EL Ziggy's Avatar
 
Join Date: Jun-2013
Location: ATL
Posts: 6,744
Country:
Re: Newbie set up questions
Where are you placing the thermostat probe Spiral? I put my probe between the UTH and the bottom of the outside of the enclosure. There shouldn't be any wires inside the enclosure. UTHs generally heat up in just a few minutes. Do you have a picture of your setup?
__________________
0.1 Albino Bull Snake (She-RA)~ 1.0 Snow Bull Snake (Apollo)~ 1.0 Coastal Carpet Python (Chomper)~ 1.0 JCP (Shredder)~ 1.0 Bredl Python (S'ven)~ 0.1 JJ x JCP (Trinity)~ 0.1 Albino Carpet Python (Akasha)~ 1.0 Olive Python (Nigel)~1.0 Scrub Python (Klauss)~ 1.0 BCI (Monty)~ 0.1 BCO (Xena)
EL Ziggy is offline  
Closed Thread

« Previous Thread | Next Thread »
Thread Tools
Display Modes
Linear Mode Linear Mode

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts
BB code is On
Smilies are On
[IMG] code is On
HTML code is Off
Forum Jump


All times are GMT -6. The time now is 03:24 AM.

Powered by vBulletin®
©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 2002-2023, Hobby Solutions.

Home      UserCp      Register      Members      F.A.Q.      Search
Contact Us - sSnakeSs.com - Archive - Top
right