|
Used UTH
So, ive been setting up my tank slowly for the BRB I am getting soon. I ran a test run with the the UTH with the water bowl over it, and it seemed to get nice and humid fairly quickly which is good and an ambient temp of around 79 right in the middle of the tank. The UTH is set on 84 degrees and the other side of the tank should be in the low to mid 70s. However after a few hours the UTH fell off. It is a used UTH I got from a friend and I have read another thread about re-using them and I am planning on using some foil tape to re-attach it.
When I do so, what is the best way to do it. Should I stick it on with the remaining adhesive and tape over the entire outside? Or should I layer the adhesive side with the tape on attach it that way? Any advice would be appreciated.
|
Threaded Mode