border
sSNAKESs : Reptile Forum
 

Go Back   sSNAKESs : Reptile Forum > Community Forums > General Discussion

Notices

 
 
Thread Tools Display Modes
Prev Previous Post   Next Post Next
Old 02-18-03, 02:36 PM   #1
nouserpif
Member
 
Join Date: Sep-2002
Location: Victoria,BC, Canada
Age: 35
Posts: 532
Incubator...

I found these instructions for building an incubator, are they any good? And how much would all this cost, apprx. ?

"You will need a submersible aquarium heater, a one gallon pickle jar or similar glass, water container, a styrofoam box deep enough for the jar to stand up in allowing clearance for the heater and a good thermometer.

First, decide where the incubator is going to be located.
Stand the jar in one corner of the box. Place the heater in the jar and fill to appropriate level, READ THE DIRECTIONS FOR OPERATING THE HEATER. You will need to cut a small notch in between the lid and edge of the box for the cord. Place the sensor for the thermometer where the egg container will sit. Turn the heater on, and allow to run for about a week, adjusting as required to stabilize the temperature. Remember to keep the water at the correct depth for the heater, it will evaporate a little. "

Thanks!
Dan Conner
__________________
Check out my friends band... The vendors! Alternative/pop-punk.
thevendorsonline.tripod.com
nouserpif is offline  
Login to remove ads
 

Thread Tools
Display Modes

Posting Rules
You may not post new threads
You may not post replies
You may not post attachments
You may not edit your posts

BB code is On
Smilies are On
[IMG] code is On
HTML code is Off

Forum Jump


All times are GMT -6. The time now is 12:47 PM.

Powered by vBulletin®
©2000 - 2024, Jelsoft Enterprises Ltd.
Copyright © 2002-2023, Hobby Solutions.

right