New to forum thinking of getting a ball python

[udyr]

Hi New to the forums how is everyone today, lately I have been thinking about getting a ball python. I have a few question before actually getting one

1.Why does the normal one cost less than ones with different color?

2.I don't know how to build a cage for it, aquarium tank or a plastic box? general cost to make one?
(links in the forum with guides would be helpful I have trouble navigating through the forums)

3.I only had fish never had a reptile, are snakes easy to take care of?

any links with information about ball pythons would be much appreciated

[Pareeeee]

1. Normals are very common and breeders usually sell them off cheap so they can continue breeding "fancy" ball python morphs.

2. Mine is kept in a 39qt tub. IMO tubs are the best enclosure for ball pythons because it's very easy to keep the humidity up. Tubs around 41qt are fine for adult BPs. Tubs are definitely the cheapest to make. Be sure to drill a row of small holes around the sides for air ventilation.

Things you'll need: Heat tape or a heat mat - NEVER heat a snake enclosure without a thermostat. The heat mat under the warm side of your enclosure should be at 95 F.

This is a good thermostat: http://www.amazon.ca/Jumpstart-Digit.../dp/B000NZZG3S

You'll need two hides the same size. Put your heat mat under one.

You need to keep the humidity at about 60%, and up to 80% when the snake is shedding. A large water dish and misting will help keep the humidity right.

3. Snakes are easy to take care of if you have the correct set up. Of my three snakes, the most difficult one I own is my Ball Python. I would recommend a Corn Snake or Rosy Boa as a beginner snake. If you decide to get either of those instead, they require different temps and humidity. Don't be afraid to ask if you have any more questions.