I'm breeding leo and I was needing 2 incubator (male and female)
so I did one which has 2 separate temperature.
it's made of 5/8 melamine, with 1inch Foam for house.
I sealed with Hot glue and used stainless steel wire for holding
the plastic sheet.
I have cheap submersile heater so I have a 2-3 degree fluctuation
but I'll try to get a 0.5F ebo-jagger precise one.
here's the pics:
wood cost me 20$, 7$ for foam, 2$ for wire, 5$ for screw/hooks
9$ for plastic drawer (for water) so it's around 40$cdn (not including Thermometer and water heater I already had)
Linear Mode
