formica
03-06-14, 03:06 PM
Thinking about building a PVC incubator, never built one before, but they dont seem too complicated?
so far it will be PVCX 10mm, around 2ft cube, with 2 shelves
thermostat connected to inlaid 36W heat cable (inlaid around the internal walls)
thermostat connected to a slow fan for cooling
a water tank with a tropical fish tank heater, in the bottom
one door, lift up, on the front, with a good 10-15cm above the door so it doesn't allow to much heat out
hygrometers and thermometer with alarm
anything else I need to think about?
so far it will be PVCX 10mm, around 2ft cube, with 2 shelves
thermostat connected to inlaid 36W heat cable (inlaid around the internal walls)
thermostat connected to a slow fan for cooling
a water tank with a tropical fish tank heater, in the bottom
one door, lift up, on the front, with a good 10-15cm above the door so it doesn't allow to much heat out
hygrometers and thermometer with alarm
anything else I need to think about?